Bronze Bar Stock

Bronze Bar Stock

Bronze bar stock is a machining material widely used for manufacturing plain bearings, bushings, valve components, wear plates, and precision parts where corrosion resistance, low friction, and dimensional stability are required. Unlike ferrous materials, bronze machines cleanly, has self-lubricating properties in some alloy grades, and performs well in applications involving sliding contact, marine exposure, or corrosive environments. AIMS Industrial supplies bronze bar stock in round, hexagonal, and flat profiles to workshops and machine shops across Australia.

Bronze Alloy Grades

Different bronze alloys are suited to different service conditions. The most common grades used in engineering applications are:

• Phosphor bronze (C93200 / SAE 660): The standard engineering bronze for bearing and bushing manufacture. Excellent machinability, good load capacity, and strong corrosion resistance. The go-to grade for general bearing applications where plain bearings are being made to order.
• Leaded bronze: Higher lead content improves machinability and provides enhanced embedded lubricity. Suited to applications with intermittent lubrication or where the bearing will run with minimal lubricant film.
• Aluminium bronze: Higher strength and excellent corrosion resistance — particularly in marine and saline environments. Used for marine hardware, pump components, and high-load bearing applications where standard phosphor bronze lacks sufficient strength.
• Silicon bronze: Good weldability and corrosion resistance. Used in marine fastener and fitting manufacture where a weldable bronze is required.

Available Profiles

AIMS supplies bronze bar in the three most practical profiles for machining operations. Round bar is the standard starting material for bearing and bushing manufacture — the round cross-section minimises material waste when turning to size. Hex bar suits production of bolt-on components, valve parts, and hydraulic fittings where wrench flats are required. Flat bar suits wear strips, slide plates, and components machined from a flat profile.

Cutting and Machining

Bronze machines excellently with HSS and carbide tooling. Sharp tools, adequate cutting fluid, and positive rake angles produce clean finishes with minimal burring. Bronze is non-sparking, which is an advantage when machining in environments where flammable dust or vapour may be present. Material can be cut to length from stock bar using a bandsaw or cold saw — power hacksaws can be used for lighter cuts but produce a rougher finish that requires more machining allowance.

Order Bronze Bar from AIMS Industrial

AIMS Industrial supplies bronze bar stock to machine shops, maintenance workshops, and engineering facilities across Australia. We can cut to approximate length for your job. For sizing advice, alloy selection, or bulk orders, contact our team and we will help you get the right material for your application.