Pferd Policap Abrasive Caps & Holders C Type 110pc

• 110pc POLICAP Abrasive Caps & Holders C Type PCS 110 C
• PFERD has based the POLICAPå¬ set tool selection on the most common applications.

• 5 pcs. each of POLICAPå¬ abrasive caps
  PC 1015 C A, 1317 C A and 1626 C A
  (grit sizes 60, 150, 280)
• 10 pcs. each of POLICAPå¬ abrasive caps
  PC 0511 C A and 0713 C A
  (grit size 60 and 80, 150, 280)
• 1 pc. each of POLICAPå¬ abrasive cap holder
  PCT 0511 C/3, 0713 C/3, 1015 C/3, 1317
  C/6 and 1626 C/6
• POLICAPå¬ tools have a seamless design and the entire tool surface can be used.
• Matching, reusable holders in various shapes are available for using abrasive caps and cones.
• The high degree of fitting accuracy between the components ensures that the abrasive caps and cones remain securely attached to the holder during use.

• Because of slots, the holder expands during use, guaranteeing that the abrasive cap/ cone is firmly clamped in place
• Good dimensional stability and excellent fine grinding thanks to a special manufacturing process
• Easy tool change

• Fine grinding in tool and mould construction
• Finishing on turbine blades after repair
• Feather edging of radii at transitions after milling frames in aircraft construction
• Fine grinding of hard-to-reach areas and bores
• Levelling of transitions in fitting and pump construction

• Abrasive caps and cones can be mounted and removed by turning them slightly to the right
• Abrasive caps and cones are easier to replace when the holder is mounted on the tool drive
• Abrasive caps and cones achieve their best performance at a recommended cutting speed of 10̐20 m/s

• The maximum permitted peripheral speed is 25 m/s
• For safety reasons, it is imperative to remain within the stated maximum permitted rotational speed at all times