Description

WD-40 Specialist Fast Drying Contact Cleaner

WD-40 Specialist Contact Cleaner blasts away oil, dirt, flux reside and condensation from sensitive electronics and electrical equipment.
It rapidly penetrates into hard-to-reach areas and dries quickly, without leaving any residue and removes oil and dirt, making it the best at cleaning electrical contacts.
Safe and ideal for use on electrical equipment such as printed circuit boards, contacts, controls, battery terminals, switches, precision instruments and electric panels.

Applications

Features & Benefits

* Always test on an inconspicuous area before use.

Fluid Properties

BOILING POINT (INITIAL)	60°C
SOLUBILITY IN WATER	Insoluble
VAPOR PRESSURE	25kPa at 20°C
PERCENT VOLATILE	Not determined
COEFFICIENT OF WATER/OIL DISTRIBUTION	Not determined
FLASHPOINT	-33°C
SPECIFIC GRAVITY	0.66 typical at 15°C
pH	Not applicable
RELATIVE VAPOR DENSITY	3.0
VOC	>90%
APPEARANCE/ODOR	Colorless liquid with a strong petroleum odor
FLAMMABLE LIMITS	LEL: 1.2 UEL: 7 (Isohexane)

Directions

Isolate all power & allow any hot surfaces to cool.
Make sure all stored power Is drained from the system.
Shake can well.
Spray directly onto the electronic device or circuit board to eliminate and remove any contaminants that may cause loss of electrical contact.
Tilt surface while cleaning and allow any excess cleaner to run off.
Allow product to dry completely and thoroughly.
Vent the system before restoring power.