Champion D1400-8 External Circlip Metric 8mm, Pack of 100

Champion D1400 external circlips are metric shaft circlips (snap rings) packed as refills for the Champion CA5015 External Circlip Metric Assortment Kit. They sit in a groove on a shaft and hold bearings, gears, pulleys and pins in place along the shaft without a separate locking fastener.

This page covers 20 sizes from 6mm to 50mm, sold by the pack: 100 per pack for 6mm to 12mm, 50 per pack for 14mm to 20mm, and 25 per pack for 22mm to 50mm. Pick the size that matches your shaft diameter, or the compartment you are restocking in the CA5015 kit.

Where this product is used

• Restocking the Champion CA5015 External Circlip Metric Assortment Kit
• Axial retention of bearings, gears, pulleys and collars on shafts
• Gearboxes, driveshafts, pins and hydraulic cylinders
• Workshop, fleet and plant maintenance where circlips are replaced on reassembly

Features

• External (shaft-fit) metric circlips, 6mm to 50mm
• Champion D1400 part numbers, one size per pack
• Bulk packs of 100, 50 or 25 depending on size
• Refill for the CA5015 External Circlip Metric Assortment Kit
• Holds parts in place along a shaft with no extra fasteners or machining beyond the groove

Key specifications

Choosing the right option

Match the circlip size to the shaft diameter, not the groove width. These are external circlips for shafts; for bores and housings use the Champion D1300 Internal Circlip Metric refill packs. For the complete kit see the Champion CA5015 External Circlip Metric Assortment Kit, and for the smaller CA2015 kit refills see External Circlip Metric Assortment Refill.

See also: Champion CA5015 External Circlip Metric Assortment Kit, Champion D1300 Internal Circlip Metric Refill, Champion CCP-1 Circlip Plier Set.

Using it

Fit and remove circlips with the correct external circlip pliers so the ring is not over-spread.

Check that the circlip is fully seated in its groove before putting the assembly into service.

Replace any circlip that has been distorted during removal.

Storage and handling

Keep packs closed and dry, and return unused circlips to their labelled compartment so sizes do not get mixed.

Limits and safety

Circlips store energy when spread and can spring off the pliers. Wear eye protection when fitting or removing them.