RejeX Polymer Coating Applicator Bottle | AIMS Industrial

Rejex Polymer Coating Applicator Bottle

• RejeX® is a thin-film polymer coating designed to provide a high-release protective finish for vehicles of all kinds. This very thin film – less than a micron thick – prevents stains and adhesion of common contaminants such as exhaust, bugs, oil, tree sap, bird droppings, road grime, brake dust, etc.
• RejeX should be applied to a cool, dry, clean surface. When over 30°C, be sure to apply RejeX out of direct sunlight. If the surface is too hot, the coating can cure before it has properly bonded to the surface, so it may not perform up to its potential.
• RejeX is not meant to be used on porous surfaces, highly oxidized painted surfaces, or to fill fine scratches.

Direction Of Use

• Ideally, RejeX should be applied to a cool, dry, clean surface.
• When over 30° C, be sure to apply RejeX out of direct sunlight. If the surface is too hot, the coating can cure before it has properly bonded to the surface, so it may not perform up to its potential.
• RejeX is wiped on in a rotary motion.
• Allow to dry to a haze for approximately 20 minutes, wipe off, then allow to cure for 8-12 hours (depending on the humidity; the higher the humidity, the faster the cure). Curing is required to allow the monomers (polymer building blocks) that make up RejeX to attach to the surface being treated and to cross link into a crystal-clear, impervious film. It is important to allow RejeX to cure for 8-12 hours after the haze has been wiped off. If the coating is exposed to contaminants such as oil, fuel, soot, hard water, tree sap, cleaners, etc. before it has cured, the contaminants may interfere with or embed in the protective film.