WD-40 Specialist Fast Drying Contact Cleaner

• WD-40 Specialist Contact Cleaner blasts away oil, dirt, flux reside and condensation from sensitive electronics and electrical equipment.
• It rapidly penetrates into hard-to-reach areas and dries quickly, without leaving any residue and removes oil and dirt, making it the best at cleaning electrical contacts.
• Safe and ideal for use on electrical equipment such as printed circuit boards, contacts, controls, battery terminals, switches, precision instruments and electric panels.

• Printed Circuit Boards
• Controls
• Switches
• Tape Heads
• Precision Instruments

Features & Benefits

• Fast acting, Non-conductive Cleaner
• Cleans Sensitive Electronic Equipment
• Penetrates Quickly & Leaves No Residue
• Plastic* & Metal Safe
• Quick Drying

* Always test on an inconspicuous area before use.

Fluid Properties

BOILING POINT (INITIAL)
60°C
SOLUBILITY IN WATER
Insoluble
VAPOR PRESSURE
25kPa at 20°C
PERCENT VOLATILE
Not determined
COEFFICIENT OF WATER/OIL DISTRIBUTION
Not determined
FLASHPOINT
-33°C
SPECIFIC GRAVITY
0.66 typical at 15°C
pH
Not applicable
RELATIVE VAPOR DENSITY
3.0
VOC
>90%
APPEARANCE/ODOR
Colorless liquid with a strong petroleum odor
FLAMMABLE LIMITS
LEL: 1.2 UEL: 7 (Isohexane)

Directions

• Isolate all power & allow any hot surfaces to cool.
• Make sure all stored power Is drained from the system.
• Shake can well.
• Spray directly onto the electronic device or circuit board to eliminate and remove any contaminants that may cause loss of electrical contact.
• Tilt surface while cleaning and allow any excess cleaner to run off.
• Allow product to dry completely and thoroughly.
• Vent the system before restoring power.