CRC Rust Converter 1L

CRC Rust Converter is a rust converter for lightly rusted metal surfaces. It rapidly neutralises rust and turns rust into a black surface ready for priming, with no sandblasting or grinding required. It comes as 250ml, 1L and 5L liquid packs and a 425g aerosol.

It suits cars, truck frames and beds, boats and trailers, railings, fences, iron or steel furniture, equipment and tools. It is not a rust preventative coating, and the liquid and aerosol have different safety classifications, listed below.

Where this product is used

• Cars, truck frames and truck beds
• Boats and trailers
• Railings and fences
• Iron or steel furniture
• Equipment and tools

Features

• Rapidly neutralises rust and turns it into a black surface ready for priming
• For lightly rusted metal surfaces, with no sandblasting or grinding required
• Liquid: works with CRC Metal Armour and most decorative paint systems for metals
• Liquid: touch dry in 20 minutes, clean up with water
• Liquid: working temperature range up to 120°C
• Four packs: 250ml, 1L and 5L liquid, and a 425g aerosol

Key specifications

Choosing the right option

For the liquid packs, for long-term results coat the converted surface with CRC Metal Armour as a protective primer coat. CRC Prep It and CRC Coloured Zinc can be used as overcoats.

The liquid is applied by brush, roller or sprayer and is not classified as dangerous goods. The aerosol is an extremely flammable aerosol, UN 1950.

See also: CRC Metal Armour, CRC Prep It Anti-Corrosive High Build Easy Metal Primer 2114 - 400ml, CRC Prime It Anti-Corrosive Primer for Steel 2091 - 400ml, CRC Heavy Duty Zinc Rich Anti-Corrosive Coating.

Using it

Preparation: remove blistered, loose paint, other coatings and loose or heavy rust scale with a scraper or mechanical sander. Remove dirt, grease and oil from the surrounding surfaces and mask the surrounding area. Rubber gloves are recommended. Apply only at 10°C to 32°C.

Liquid: mix or shake well and pour the estimated amount into a clean container; it cannot be returned to the original container. Work it into the rusted surface with a synthetic bristle brush for maximum penetration, or use a roller or sprayer for large areas. Clean equipment with cold water immediately. Allow at least 12 hours cure before overcoating. Overcoat with an enamel topcoat; with a water-based topcoat, use a stain-blocking primer.

Aerosol: shake well. If the first coat does not fully convert the rust, apply a second coat once it is dry.

Test on a small inconspicuous area first.

Storage and handling

Liquid: store above 5°C and protect from freezing. Aerosol: keep away from heat and ignition sources; check the safety data sheet for storage limits.

Limits and safety

It may not prevent further rusting when applied to heavy rust scale, is not suitable as a rust preventative coating, should never be used to treat steel that is new or not rusty, and is not designed for non-ferrous metals, galvanised or stainless steel. Liquid packs (250ml, 1L, 5L): Warning. Skin irritation (H315) and serious eye irritation (H319); not classified as dangerous goods. 425g aerosol: Danger. Extremely flammable aerosol (H222), pressurised container that may burst if heated (H229), serious eye irritation (H319), may cause drowsiness or dizziness (H336), and repeated exposure may cause skin dryness or cracking. UN 1950, Aerosols, Class 2.1. Read the safety data sheet before use.