Anchor Shield Silver Gal Galvanising Paint 1L, 58029-1

Anchor Shield Silver Galvanising Corrosion Protection (Silver Gal) in 1L, 4L and 20L, maker codes 58029-1, 58029-4 and 58029-20.

The maker's catalogue presents Silver Gal as a silver finish that protects and matches in one step, for re-galvanising damaged areas on galvanised steel, with corrosion protection and fast drying (manufacturer-stated).

The maker's data sheet describes it as fast drying with high adhesive strength, ready for use by spray gun with no thinning needed, and says it may be applied by brush to small areas (manufacturer-stated).

Where this product is used

• Re-galvanising damaged areas on galvanised steel
• Repairing damaged spots on galvanised parts
• Welding and cutting points in steel constructions
• Clean mild steel, weld areas and galvanised sheeting

Features

• Corrosion protection with a colour match to newly galvanised metal (manufacturer-stated)
• Fast drying with high adhesive strength (manufacturer-stated)
• Ready for use by spray gun; thinning is not required (manufacturer-stated)
• May be applied by brush to small areas (manufacturer-stated)
• At 20°C and a 25 micron film: dust free in 5 minutes, touch dry in 20 minutes, recoat after 1 hour, hard dry in 16 hours (manufacturer-stated)

Common specifications

Application (maker guidance)

Remove rust, dirt, wax and other contaminants, clean with wax and grease remover and make sure the surface is dry. Lightly sand pre-painted surfaces with 320 grit sandpaper (manufacturer-stated). The data sheet names Anchor Etch Primer, Anchor Industrial Structural Primer and Anchor Shield Cold Gal as primers for prepared surfaces, and says to use Cold Gal or Structural Primer before Silver Gal for rust protection (manufacturer-stated). Mix thoroughly, lifting any settled material off the bottom with a flat bladed spatula, and stir frequently during use (manufacturer-stated). Apply 2 coats with at least 1 hour between coats (manufacturer-stated). Clean equipment with xylene, enamel thinners or all purpose thinners (manufacturer-stated).

Key specifications

Selecting the right option

Choose the size: 1L (58029-1), 4L (58029-4) or 20L (58029-20). Match the maker code in the table to the variant you select. Silver Gal is also sold as a 300g aerosol.

Related products

Also from Anchor: Silver Gal aerosol, Cold Gal liquid, Industrial Structural Primer, Industrial Etch Primer and Anchor Industrial zinc protection coatings.