Pferd 43204001 Pencil Brush PBU 10 x 10 mm, 6 mm Shank, Steel Wire 0.35 mm

The Pferd PBU is a crimped pencil (end) brush. It has a 6 mm shank and steel wire filament. This page lists 7 items in 5 sizes: 10 x 10 mm, 13 x 12 mm, 15 x 16 mm, 20 x 22 mm and 30 x 29 mm (brush diameter and cup diameter). Some sizes come in more than one filament diameter.

The catalogue describes the PBU as suited to light brushing such as deburring, cleaning and derusting (manufacturer-stated).

Filament diameters are 0.20 mm, 0.35 mm and 0.50 mm. Optimum and maximum speeds depend on the size: maximum speeds run from 15,000 to 20,000 rpm, so check the figures for the item you choose (manufacturer-stated).

Steel wire: high tensile and bending fatigue strength, temperature resistance up to 300°C (manufacturer-stated).

Special features listed in the catalogue: the wires spread out on rotation, which gives access to hard-to-reach areas such as drilled holes and cavities; creates fine surfaces (manufacturer-stated).

Where this product is used

• Suited to light brushing such as deburring, cleaning and derusting (manufacturer-stated)
• Steel wire is rated highly suitable for steel and cast iron, and suitable for plastics (manufacturer-stated)
• Access to drilled holes and cavities (manufacturer-stated)

Features

• Brush diameter and cup diameter: 10 x 10 mm, 13 x 12 mm, 15 x 16 mm, 20 x 22 mm and 30 x 29 mm
• 6 mm shank (manufacturer-stated)
• Steel wire (ST), filament diameters 0.20 mm, 0.35 mm and 0.50 mm (manufacturer-stated)
• The wires spread out on rotation, which gives access to hard-to-reach areas such as drilled holes and cavities (manufacturer-stated)
• Creates fine surfaces (manufacturer-stated)

Common specifications

Key specifications

Each item number is a separate size. Speeds are shown for each item.

Selecting the right option

Match the 6 mm shank to your chuck or collet. Larger brushes can have lower speed limits, so read the speed columns in the table for the item you choose. The catalogue gives a recommended cutting speed of 5 to 15 m/s for end brushes, depending on the application and below the maximum permitted speed (manufacturer-stated). Steel wire is rated not suitable for stainless steel, aluminium or non-ferrous metals (manufacturer-stated). Never exceed the maximum permitted speed marked on the brush, its label and in the catalogue (manufacturer-stated).

Related products

The same PBU range in stainless steel wire, and the POS items: Pferd Pencil Brush PBU, Stainless Steel Wire, 6 mm Shank, 10 x 10 to 30 x 29 mm and Pferd Pencil Brush PBU (POS), Steel Wire, 6 mm Shank, 15 x 16 and 20 x 22 mm.