Euroboor pilot pins for annular cutters, 8 / 90

Euroboor ejection pilot pins centre an annular cutter, control the oil flow and eject the slug. There are 10 pins, 6.35mm (1/4") or 8mm (5/16") in diameter and from 77mm to 252mm long.

Pilot pins are essential for the use of annular cutters: the pin locks off the oil flow while the machine is at a standstill, is pushed into the machine when drilling starts so that oil flows into the cutter for cooling and lubricating, and pushes the slug out when the cutter is through the material, by means of a strong spring inside the magnetic drilling machine.

Where this product is used

• Centring an annular cutter on a magnetic drilling machine
• Ejecting the slug from the cutter once the hole is through
• Controlling the oil flow to the cutter

Features

• Positions the cutter precisely
• Locks off oil flow at a standstill and permits flow when drilling starts
• Ejects the slug with the spring inside the magnetic drilling machine
• 6.35mm (1/4") and 8mm (5/16") diameters
• Lengths from 77mm to 252mm

Key specifications

Choosing the right option

Match the pin to the cutter using the cutter table above, then check the diameter and length in the variant table: the 6.35mm pins are IBC.70, IBC.75, IBC.90 and IBC.K50, and the 8mm pins are IBC.80, IBC.85, IBC.100, IBC.130, IBC.140 and IBC.150. The cutter pages are HSS 30mm depth of cut, HSS 55mm depth of cut, TCT 35mm depth of cut and TCT 55mm depth of cut.

See also the Euroboor annular cutters on: HSS 30mm depth of cut, TCT 55mm depth of cut, MT2 arbor.