CRC TAC-2 Adhesive Lubricant Aerosol 300g

CRC TAC-2 is an adhesive lubricant that bonds to chain and wear surfaces, supplied as a 300g aerosol. It penetrates chain pin and bushing areas and wire rope strands, then thickens into a long lasting lubricant, and gives a temperature range of -25 °C to +165 °C.

It resists cold, hot and salt water wash-off and high temperature sling-off. The film is non-drying.

Where this product is used

• All types of chain drives
• Open gears
• Hoists, conveyors, fork lifts and wire ropes
• Car wash equipment and bottling plant
• Tractors, farm equipment and cement trucks
• Marine applications, where salt water resistance matters

Features

• Adhesive lubricant that bonds to chain and wear surfaces
• Penetrates chain pin and bushing areas and wire rope strands, then thickens
• Temperature range -25 °C to +165 °C
• Resists cold, hot and salt water wash-off and high temperature sling-off
• Non-drying film
• Hydrocarbon propellant

Key specifications

Choosing the right option

This is the flammable formulation. For a non-flammable version see CRC TAC-2 Adhesive Lubricant Non-Flammable 400g - Pack of 6, which has different chemistry and its own data. For a gel-type lubricant see CRC Gel-TAC Synthetic Adhesive Lubricant 350g.

See also: CRC TAC-2 Adhesive Lubricant Non-Flammable 400g - Pack of 6, CRC Gel-TAC Synthetic Adhesive Lubricant 350g, CRC Aerosol Wire Rope & Cable Lubricant 285g, CRC Moto Chain Lubricant Aerosol 1752431 - 400ml.

Using it

Read all directions and warnings. Switch off and de-energise the equipment, and shake the can well.

On a chain, apply to the upper edges of the overlapping side plates and let the lubricant set up before energising.

On wire rope, coat the whole surface so it penetrates between the strands. Spray an even coat over the entire wear surfaces. Do not apply while equipment is energised.

Storage and handling

Keep the can away from heat and ignition sources and do not expose it to temperatures above 50 °C.

Limits and safety

Hazard classification: signal word Danger. Extremely flammable aerosol (H222). Pressurised container: may burst if heated (H229). Causes skin irritation (H315). May cause drowsiness or dizziness (H336). Toxic to aquatic life with long lasting effects (H411). Transport class: UN 1950, Aerosols, Class 2.1, with a marine pollutant entry. Keep away from heat and ignition sources. Do not apply while equipment is energised. Read the safety data sheet before use.