Loctite 424 Instant Adhesive for Plastic & Rubber 25ml

Loctite 424 is a one-part, low viscosity ethyl cyanoacrylate instant adhesive. It cures with moisture and needs no mixing. Its key substrates are plastics and rubbers, with enhanced performance on EPDM and other elastomers.

At 22 °C and 50% RH it fixtures in under 5 seconds on neoprene and nitrile rubber and in 15 to 30 seconds on degreased mild steel. It suits thin bond gaps.

Where this product is used

• Bonding plastics such as ABS, PVC, polycarbonate and phenolic
• Bonding rubbers such as neoprene and nitrile rubber
• EPDM and other elastomers
• Thin bond lines, with a 0.05mm gap recommended

Features

• One part, no mixing
• Low viscosity: 95 to 125 mPa·s (Brookfield LVF, 25 °C)
• Enhanced performance on EPDM and other elastomers
• Under 5 seconds to 0.1 N/mm² shear on neoprene and nitrile rubber (22 °C, 50% RH)
• 18 to 26 N/mm² lap shear on grit-blasted steel (24 h at 22 °C, ISO 4587)
• Humidity cure, full chemical and solvent resistance after at least 24 hours
• Softening point of 165 °C (DIN EN 1427)

Key specifications

Choosing the right option

Loctite 424 is the grade to look at for rubbers, especially EPDM. For plastics and rubbers with a thinner liquid, see Loctite 406 Instant Adhesive for Plastics and Rubbers; for a general purpose grade that also covers metals and porous materials, see Loctite 401 Instant Adhesive.

For a rubber-toughened grade, see Loctite 435 Toughened Instant Adhesive 25ml.

See also: Loctite 406 Instant Adhesive for Plastics and Rubbers, Loctite 401 Instant Adhesive, Loctite 435 Toughened Instant Adhesive 25ml, Loctite 416 Super Bonder Instant Adhesive 25ml.

Using it

The product suits thin bond gaps (0.05mm). Thin bond lines cure faster and wider gaps slow the cure.

Fixture times are the time to 0.1 N/mm² shear at 22 °C and 50% RH, and vary by substrate.

Full chemical and solvent resistance takes at least 24 hours.

After 1,000 hours it keeps 100% of its initial strength in gasoline, isopropanol and ethanol, and 95% in motor oil at 40 °C.

Storage and handling

Store unopened, in a dry place, at 2 °C to 8 °C. Storage below 2 °C or above 8 °C can adversely affect the properties of the product.

Limits and safety

Not recommended for pure oxygen or oxygen-rich systems, or as a sealant for chlorine or other strong oxidising materials. Read the safety data sheet before use.